Hotpoint LSB5B019XUK Instructions for use Page: 15

Hotpoint LSB5B019XUK Instructions for use Page: 15
GB
15
Troubleshooting
*Onlyavailableinselectedmodels.
Whenevertheappliancefailstowork,checkforasolutionfromthefollowinglistbeforecallingforAssistance.
Problem: Possible causes / Solutions:
The dishwasher cannot be started or
controlled.
Switch off the appliance by pressing the ON/OFF button. Switch it back
on after approximately one minute and reset the program.
The appliance has not been plugged in properly.
The dishwasher door has not been shut properly.
The door won’t close.
The lock was released. Strongly push the door until a “clacking” noise is
heard.
No water drains from the
dishwasher.
The dishwasher cycle has not finished yet.
The water drain hose is bent (see Installation.)
The drain duct is blocked.
The filter is clogged up with food residues.
The dishwasher is too noisy.
The dishes are rattling against each other or against the sprayer arms.
An excessive amount of foam has been produced: the detergent has not
been measured out correctly or it is not suitable for use in dishwashers
(see Start-up and use.)
The dishes and glasses are
covered in a white film or
limescale deposits.
The level of refined salt is low or the dosage setting is not suited to the
hardness of the water (see Rinse aid and salt.)
The lid on the salt dispenser was not closed properly.
The rinse aid has been used up or the dosage is too low.
The dishes and glasses are
streaked or have a bluish tinge.
The rinse aid dosage is too high.
The crockery has not been dried
properly.
A wash cycle without a drying cycle has been selected.
The rinse aid has been used up or the dosage is too low (see Rinse aid
and salt.)
The rinse aid setting is not suitable.
The crockery is made from non-stick material or plastic.
The crockery is not clean.
The racks are overloaded (see Loading the racks.)
The crockery has not been arranged properly.
The sprayer arms cannot move freely.
The wash cycle is too gentle (see Wash cycles.)
An excessive amount of foam has been produced: the detergent has not
been measured out correctly or it is not suitable for use in dishwashers
(see Start-up and use.)
The lid on the rinse aid compartment was not shut correctly.
The filter is dirty or blocked (see Care and maintenance.)
The refined salt level is low (see Rinse aid and salt.)
The dishwasher does not take any
water in - Tap shut-off alarm.
Beeps are heard * and the Washing
indicator light is ashing quickly.
Beeps are heard* and the Drying and End
indicator lights are ashing quickly.
There is no water in the mains supply.
The water inlet hose is bent (see Installation.)
Turn on the tap and the appliance will start after a few minutes.
The appliance stopped because no action was taken when the beep
sounded*.
Switch off the machine using the ON/OFF button, turn on the tap and
switch the machine back on after a few seconds by pressing the same
button. Re-program the appliance and restart the wash cycle.