Hunter Industries Soil-Clik Instructions Card Page: 2

Connecting the Probe to the Soil-Clik Module
Connect the gray/black probe wires to the two gray Soil-Clik module
wires with waterproof connections (polarity is not important in this
system).
Connecting the Probe to NODE-BT
Cut the clear waterproof seal on the gray two wires connected
to the controller. Connect the gray/black probe wires to the two
gray NODE-BT wires with waterproof connections (polarity is not
important in this system). The Soil-Clik module is not used with
NODE-BT installations.
Use only 18 AWG (1 mm)
or larger direct burial
rated wire, up to 100'
(30 m) from NODE-BT.
Use only 18 AWG
(1 mm
2
) or larger direct-
burial-rated wire, up
to 1,000' (300 m) from
the module.
Yellow
White
To Soil-Clik Probe
Gray/Black
To Soil-Clik
Probe Gray
LIT-633-IC C 7/20
© 2020 Hunter Industries Inc. Hunter, the Hunter logo, and all other trademarks are property of Hunter Industries, registered in the U.S. and other countries.
hunter.direct/soilclik
Avoid high-voltage lines and other sources of electrical interference.
Installing the SC-PROBE (continued)
Pack native soil tightly around probe. Soil must be in full contact
with probe.
Allow the probe to acclimate for two to three days and water
normally before proceeding to sensor-based irrigation.